Subject: Turbo apex seal fracture
From: ACRE NL
Date: 9/27/2002, 10:18 PM


 > > If you are planning a turbo it is a good idea to install
 > one piece 3 mm apex seals. Something as simple as a plugged
 > injector or a weak fuel pump can cause the engine to run
 > lean at high power and ping. One ping can fracture a stock
 > apex seal.
 >
 > Paul Lamar

 Who can set up rotors to 3mm apex seals?  Have a set of Hurley 3mm.

 Barny MGDQ


I am not sure who can do that in the States. Lynn might know.
Also Bruce Turrentine might know. Any grinding shop should be
able  do it with enough work to make it worth their while.

It is also a good way to recover a rotor with worn apex seal
slots. You might have to ship  your rotors to England. BTW
has Hurley responded to email lately?

Actually it is pretty easy to build a machine yourself to do it.
What you do is buy a small milling and drilling table from a machine
shop supply place such as Airgas. They run as little as $177.
all you need is slightly over three inches of travel...the long way!
http://www.airgas.com/

Mount a small cut off hand grinder on a welded up two inch square
steel tube box frame and mount the rotor on the milling table
with an angle plate.

Cutoff disk width is about .046" so it will fit in the
2 mm original slot with. Cutoff disk are about $4 each so you
can throw them away when they are worn.

2 mm = 0.0788"
3 mm = 0.1182"

So all you need grind off both sides of the slot is 0.0197"
or .5 mm.

I learned this trick from Tracy Crook as he built a Ford sun gear
grinder using his lathe and a bench grinder.

When you get this built let me know and I will send you a lot
of business :-) You could operate this business out of a closet.

Paul Lamar


   I have my rotors cut for the 3mm seals by Rob Golden at Pineapple
racing in Portland OR
  I don't have a number for him off hand but I am sure info has it.

  Ken Welter

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.