Subject: Aluminum end housings
From: ACRE NL
Date: 9/30/2002, 11:56 AM


Tom Webber wrote:

How many people are interested in these aluminum end housings?
There is a possibility that they will be made available for
one rotor use. Either milled down with donor Mazda end housing
cast iron wear surfaces or with expensive detonation gun coatings
of carbide particles and then surface ground for minimum weight.

That is Jerry Hey taking a picture :-)


Paul Lamar

Paul,  I'd be interested in aluminum side housings, for the single
rotor.

Tom Webber

Mike Collier wrote:

Paul, I would be interested also if they would work on a two rotor, will
they? how would they compair in price and weight to what Racing Beat is
offering?  I really like what they offer but the $ are very steep. I've
been Out sick lately and may have missed an earlier post that answered this
already. Do you have any pictures?

Thanks
Mike C.

Yes they will work on a 13B but the percentage weight saving
will not be as significant as it is on the one rotor.
They will be expensive if we go the det. gun coating route. Probably
in the same ball park as Racing Beat. One difference is these
are side ported and the RB's are P-ported.

If we go the the milled down stock Mazda end housing wear surface
route the cost could be much less at a slight weight penalty.
Det. gun coatings are expensive.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.