Tom Webber wrote:

 How many people are interested in these aluminum end housings?
 There is a possibility that they will be made available for
 one rotor use. Either milled down with donor Mazda end housing
 cast iron wear surfaces or with expensive detonation gun coatings
 of carbide particles and then surface ground for minimum weight.

 That is Jerry Hey taking a picture :-)

 Paul Lamar

 Paul,  I'd be interested in aluminum side housings, for the single
 rotor.

 Tom Webber

Tom,  these are on the shelf ready to deliver from Racing Beat.
$1550.00 each.   Jerry

Hi Paul and group, I find it hard to comprehend such prices as I can
buy the 40 to 50 mm plate for $80.00 AUS. How much does it cost to to
have the alloy detonation gun coating applied. What is the hardness of
the Mazda end plate finish and how is it done.
Regards Don Dunbar

--
Best regards,
 ddunbar                            mailto:ddunbar@echidna.id.au

I think the cast iron end housing are induction hardened. No idea
what Rockwell number. They could also be nitrided as I recall.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.