Jerry Hey wrote:

Paul, there is plenty of room in the lower part of the nose bowl on
each side for a Setrab  (8.25 x 7.5 x 2)  These can be mounted on
brackets welded to the lower Barry Mount assembly.  They will be fed
from the corners of the under-the-spinner inlet.   When  you get  a
chance, please take a look at it in Rhino.    Thanks,  Jerry

Don't look good. The air might try to go in the back side.
Perhaps only one in the back on the cold side would work.
This is the needed five inch dia. duct.

I still say you are better off with the stock cooler on the
cold side the long way.


Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.