Our new intake manifold is coming along.
Will fit: six port, four port, turbo all 13B
through 2002. There will be some hand finishing
of the pattern for fillets. Rhino don't do
fillets too good :-)

Several hole patterns are accommodated and shown.
93, Cosmo 13B  and later engines will require some porting
of the manifold to match up with the stock end housing ports.
You can cut away what you don't need to save a bit of weight.

Designed to use low cost pipe bends. Tubing bends
can also be used.

Core boxes are done. BTW The device shown on top of the core
boxes is a 3D model of a Yamaha twin motorcycle engine
intake manifold. Note the huge size of the ports.

I have to get this done before I can finish my turbo engine to
run on the dyno/prop-test stand.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.