Rotary Group,
Having a friend run some prop sheets for us and there is the need to
enter
HP/RPM values.
One instance I have is for an O-360 Cozy:
RPM: 1200 1800 2250 2700
HP: 90 132 164 180
What would be representative values at meaningful datapoints for the
TO4-E
turbo'd gen 3 with mild street porting if we choose to use 7200 RPM as
our
redline?
Also needed to know the altitude at which the power data is no longer
constant and begins to vary with altitude.
...Chrissi
Cozy Mk-IV 13B-turbo
www.CozyGirrrl.com
Chrissi@BlueMountainAvionics.com
Chrissi -I do not know what flight points the supplied data is for, but it
looks rather erroneous.
At a given speed and altitude increasing rpm requires increasing HP cubed
ie
doubling rpm
requires 8 times as much power.
Power output at altitude is almost a direct function of absolute manifold
pressure that
you can obtain - "flat rating" is accomplished by making up the entry
pressure by
varying pumping of the supercharger or turbo charger - a normally aspirated
engine
starts losing power the instant you have started to gain altitude.
Hope this helps, instead of adding confusion - Vance J
Dear Vance,
The table quoted above for the 0-360 came from someone else's data entry for
the prop program
I need to come up with 4 useful data points of RPM and HP values so that the
software can characterize the engine in static thrust, climb and cruise and
then give useful information about the prop characteristives at these points.
The dyno curves were somewhat useful but I am not sure they may characterize
our engine under the conditions we would be using it. Guessing is a trash in
trash out scenario. For prop diameter and speed issues I am limiting the
engine RPMs to 7200 max worst case, would prefer to redline at 7000.
...Chrissi
Cozy Mk-IV 13B-turbo
www.CozyGirrrl.com
Chrissi@BlueMountainAvionics.com
You are going to have to slog through the Hugh MacInnis book and work
all this stuff out for yourself. Compressor maps are available
from Garrett. Some are in the turbonetics catalog. If you get
some maps that I don't already have please
send me a copy. You can get just about any
HP you want out of a turbo 13B. The HP curve you get will
depend on the turbo you choose. You will not be far off if
you choose HP as a straight line function of RPM.
In addition people with a lot of experience sizing turbo's tell
me it is not an exact science. You do the best you can and you
get whatever you get.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.