Subject: Auto Conversion Judging Was Re: Evergreen AL Fly-in
From: ACRE NL
Date: 10/9/2002, 7:12 PM


Thanks, Doug

    I agree with your assessment and I think many of us do.  Not to take
away from those who have the talent and dedication to produce a "Show
Plane", I for one admire what it takes.  With so many kit built planes now a
days, cosmetic differentiation is about all you can expect in many cases.
However, I believe most of us on the list feel that auto conversions simply
needs a different criteria about what is important.  I certainly don't hold
it against the judges who volunteer their time and have to go by the
criteria in the EAA Judging Handbook (for the most part).

    I almost immediately received a somewhat irate e mail from the SERFI
(apparently the EAA immediately sent it to them and I probably should have
done the same) and we continue to disagree on some points (including the
cosmetic aspect of judging and whether experimentation is still a focus of
the EAA).  However, the good news appears to be that the SERFI has appointed
an Auto Conversion board with Dick Simpson as its head to work out a
meaningful criteria.  While much remains to be done on establishing a
criteria, it appears that the point has been make that the focus should be
on the FWF aspects.  A couple of their initial thoughts on criteria was not
that bad and if they maintain that focus, just might come up with a
meaningful set.

    For example, the judging would be limited to auto conversions done by
individuals and no factory FWF kits would qualify .  One the other hand you
won't have to build your own PSRU as that - and certain other components
(not defined as yet) could be purchased.  However, if you did build your won
PSRU you would probably garner more points.  Aircraft appearance would not
be completely done away with, but would probably be used more as a "tie
breaker" between auto conversions.

In any case, I have offered to pull together some criteria for input to this
committee.  You know how it goes, if you complain then your' asked to put up
or shut up {:>).  I would appreciate any suggestions as to approach and
criteria input.  I personally think that perhaps a FWF should be first
broken into areas such as:  Engine Mount.  PSRU.  Engine. Ignition. Fuel
System, etc.  Then perhaps a set of common criteria for each section such as
1. Soundness of Design 2. Reliability 3.  Fail safe/graceful considerations
or what ever makes sense and can be judged. Perhaps there should also be an
"Innovation factor" for extra points?   No doubt subjective will still be
there in the judging, but this would help.  So send me any suggestions and
I'll try to organize and pull it all together and then present it to the
list for comments.

One thing of interest, they indicated that they are considering requiring
"Technical Data" and perhaps "Drawings".  While I think this could be good,
it could turn into a paper mill, so any thoughts in this area would be
appreciated.

Ed (Stir up the Pot) Anderson

Keep up the good work Ed,

Each aircraft system could be a unit by itself (electrical, hydraulics,
fuel, cooling, intake, exhaust etc...) where safety considerations and
reliability is at the top of the list.  Weight should also be one
consideration.

Drawings could be used for additional points but not required.
The drawings we make and use during construction should be good for that
requirement.

Criteria for choosing a particular engine
In the commercially available firewall forward kit versus home built
installation one should not be penalized for choosing to buy a PSRU for
example rather than build it.  Actually buying a proven PSRU should get
you more points than building a one of a kind drive because of the
inherent safety factor.

Rino

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.