Rotary Group,
Having a friend run some prop sheets for us and there is the need
to
enter
HP/RPM values.
One instance I have is for an O-360 Cozy:
RPM: 1200 1800 2250 2700
HP: 90 132 164 180
What would be representative values at meaningful datapoints for
the
TO4-E
turbo'd gen 3 with mild street porting if we choose to use 7200
RPM as
our
redline?
Also needed to know the altitude at which the power data is no
longer
constant and begins to vary with altitude.
...Chrissi
Cozy Mk-IV 13B-turbo
www.CozyGirrrl.com
Chrissi@BlueMountainAvionics.com
Chrissi -I do not know what flight points the supplied data is for,
but it
looks rather erroneous.
At a given speed and altitude increasing rpm requires increasing HP
cubed
ie
doubling rpm
requires 8 times as much power.
Power output at altitude is almost a direct function of absolute
manifold
pressure that
you can obtain - "flat rating" is accomplished by making up the entry
pressure by
varying pumping of the supercharger or turbo charger - a normally
aspirated
engine
starts losing power the instant you have started to gain altitude.
Hope this helps, instead of adding confusion - Vance J
Dear Vance,
The table quoted above for the 0-360 came from someone else's data entry
for
the prop program
I need to come up with 4 useful data points of RPM and HP values so that
the
software can characterize the engine in static thrust, climb and cruise
and
then give useful information about the prop characteristives at these
points.
The dyno curves were somewhat useful but I am not sure they may
characterize
our engine under the conditions we would be using it. Guessing is a
trash in
trash out scenario. For prop diameter and speed issues I am limiting the
engine RPMs to 7200 max worst case, would prefer to redline at 7000.
...Chrissi
Cozy Mk-IV 13B-turbo
www.CozyGirrrl.com
Chrissi@BlueMountainAvionics.com
Chrissi - I have not "shined on" your request. I have run a test case and
plotted
the power required by the prop sized by my program at the various rpm and
speed
ranges. Then my 20 year old water wheel driven inkjet printer (that will
listen
to DOS ans BASIC) went into s snit, and stopped working. The attached
poor screen photo is a quick attempt at a fix.
I estimated that the engine with modest porting and relatively vigorous
boost
should peak at about 250 bhp at 6500 shaft or about 3000 prop rpm Using
200mph as design speed the program suggests about 65 in dia and 77 in pitch.
Equiv two blade widths .9r 5.5 in .7r 6.5in, .5r 8in and .3r (arbitrary)
8in.
Three blade about 2/3 those numbers. Estimated Wankel, and book IO360
curves are overlaid for comparison.
With a more refined power curve, I could predict full thottle rpm and
thrust values. A marge Warnke "Airclaw" might be able to spread
the power a bit for better climb without giving up too much
on top and cruise. - Vance J
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.