The screws fall out all the time, use a little locktite on it.
Loktite on most plastics is a no no. It causes the plastics to go brittle and develope cracks.
...Chrissi
It is just the cap that is plastic. The screw is in metal.
Paul Lamar
Paul, it is the nature of Loktite to not harden in air, any excess flows and creeps onto the
plastic. We had serious cracking problems with a small assembly, same kind of scenario where we
thought we were safe because the screw eent into a metal insert in the plastic. Assemblers were
just not able to keep the stuff off the plastic 100% of the time. It was the sort of thing where
it always happened much later. So if you do use it, scrupulously clean the area afterwards
...Chrissi
Cozy Mk-IV 13B-turbo
www.CozyGirrrl.com
Chrissi@BlueMountainAvionics.com
As far as I can tell the cap is purely cosmetic. Maybe its function
is to save the screw when it falls out :-) On the other hand if
the screw is supposed to be loose perhaps it is a controlled leak
and the volume of the plastic cap has something to do with
the functioning.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.