Subject: On the subject of vacuum pumps can the exhaustgenerateenough vacuum
From: ACRE NL
Date: 10/14/2002, 10:30 AM


This idea might have some merit- have a small SS tube, about 1/4" dia
welded
into the last 4 inches or so of the exhaust system, post muffler. The
tube
would go in and take a sharp downstream turn. This should draw some
vacuum.
How much, I don't know, but there are NO moving parts to break, and
the
weight would be very small.
Brian Trubee


Interesting,  How about a slight taper in diameter of the tail pipe,
creating a venturi,  installing a second light housing around the tail
pipe at that location, and plumb a small tube to a vacuum reservoir.
Drive your instruments from the reservoir.  I think this should be
experimented with.  I'll draw something up.   Tom Webber

You don't need a taper or venturi.  You use a venturi on the outside to
create a pressure differential from static.  With the higher velocity of
the exhaust gasses you only need to angle a tube into the pipe.  I remember
this being done for crank case evacuation on hot rods.  The angle was 22-23
degrees from parallel-to-the-pipe.  Placement in the tuned exhaust pipe
might be critical downstream of the muffler would not.

If you use a reservoir and want to complicate it a little for some more
vacuum power, run a tube into each pipe and put an in-line read valve in
each tube like is used in air compressors.  It's a check valve that will
help keep the vacuum in the reservoir.  With some experimenting you might
find that long small diameter tubes to each pipe would actually provide a
tuned header effect so you would not need the reed valve.

Mike McGee, RV-4 N996RV, O320-E2G, Hillsboro, OR
13B in gestation mode

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.