The screws fall out all the time, use a little locktite on it.

Loktite on most plastics is a no no. It causes the plastics to go

brittle and develope cracks.

...Chrissi

It is just the cap that is plastic. The screw is in metal.

Paul Lamar

-Patrick wrote:

Hi Paul,

What I use when trying to lock a nut or screw in plastic, is low viscosity
PRC (plastic Rubber Compound )  as used to seal tanks and seal windshields
in pressurized A/C, Dab some on the thread  and you will see,it works
great.(Just takes a while to cure)

Thank' s- 

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.