Looking at the photos in the last message, I wanted to point out that I removed the oil injection pump, and needed to block the oil passage in the front housing. To do this, I drilled out the galley just big enough to fit an aprox. 1/4 in dia ball bearing which I then placed into the hole before I installed the front cover.
Brian Trubee

That is a good idea. That will take care of that potential
oil leak. I want to emphasize the ball bearing goes in the
front cast iron END HOUSING and not the aluminum front
cover. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.