Case Sinclair wrote:
So would these bearings wearout and getnoisey/sloppy fast?, How are these
centre bearings lubricated? It would seem to me that chagign the bearing to
a "plain bearing" would not be much more difficult
I wonder if they are supposing the engines will blow before the bearings are
worn out....ie high PSI turbo drag/street engines?
My local tuning house has installed a number of these EC's, but I have not
heard about thier longevity or whathaveyou,
Case
South Australia
I don't know what would happen. At 200,000 needle RPM I would imagine
they are not really working as a roller bearing should. Probably
metal to metal slipping is going on. The limiting shaft speed
in the catalog is 9400 RPM for a 45 mm caged roller bearing.
That is probably near zero load or zero life. Perhaps the rollers are
made from silicon nitride as many NC machine tool ball bearings
are. These tolerate heat above 500 F so they can run faster.
Hard to say what the load is as one would have to calculate
the deflection of the shaft.
The basic idea is good but I would be more comfortable if it
were a oil pressure fed plain bearing.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.