Subject: 2 piece 13B eccentric shaft
From: ACRE NL
Date: 10/16/2002, 10:07 PM


Marc Wiese wrote:

http://www.gurumotorsports.com/\

New 2 piece 13B eccentric shaft available.....
Marc Wiese

Interesting. Too bad they can't figure out how to get a plain
bearing in there. At 10,000 RPM I don't think that needle
bearing is of much use. Those little needles must be really
zinging along at over 200,000 RPM. The ultimate answer is
the two piece shaft with a new center housing and a
plain bearing.

Paul Lamar


However, there are some engines that do quite well with ball bearings. :-)
Royce

 This is the Magnum XLS 40A ABC 2-Stroke Glow Powered Aircraft Engine.

       FEATURES: ABC construction-Aluminum piston, Chrome-plated Brass sleeve.
                 One piece aluminum crankcase.
                 Side exhaust.
                Dual ball bearings.
                 Front-mounted carb with two needle valve adjustment and rear needle
                   valve assembly.
        SPECS:    Bore: 0.81" (20.5mm)          Stroke: 0.77" (19.6mm)
                 Displacement: 0.39" (6.47cc)  Practical RPM: 2000-17,500
                 Weight with muffler: 16.4oz (465g) Weight w/o muffler: 13.5oz (383g)

It is surface velocity that counts. Small ball bearings can run
at high speeds.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.