. Too bad they can't figure out how to get a plain
bearing in there. At 10,000 RPM I don't think that needle
bearing is of much use. Those little needles must be really
zinging along at over 200,000 RPM. The ultimate answer is
the two piece shaft with a new center housing and a
plain bearing.
Paul Lamar
Paul, The Porche Rennsport 4 cylinder roller bearing engine used a disassembleable crank. (they
did it to use roller bearings) The engine used a "tooth face spline" that was bolted togeather
before grinding. No reason the e-shaft couldn't be done the same way.
My $.02 Bill Jepson
Yes I know. That was the early days. They don't use roller bearings
anymore. Another drawback to roller bearings is you lose structural
strength in the crankcase and or the engine is larger and heavier.
Paul Lamar
Paul, I know the problems of roller bearings, I meant you could use the same tecnique to run a center plain bearing. Finish on a plain bearing journal would be easier. Bill Jepson
The Mazda method is much easier to machine.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.