Does anyone know where to get some of these? All you

can get from

Mazda is a complete wiring harness for $450. I lost one of the
spring clips that holds the connector on.

Chuck Dunlap

Chuck, two places.  You might try ThePartsTrader.com, I've

often seen

harness offered.  Or you might try Mazdaparts (Salvage Yard out of
Atlanta GA).  But, sometimes you might get lucky and find

one at your

local salvage yard.  I don't use the Mazda Connectors so

can't offer

any direct help on the spring clip.

However, here is the web page with the connectors I use

from MSD (only

fits injectors with the center key tab on the injector

connector), but

they do fit the 460/500 cc/min Mazda Injectors and are certainly
cheaper than $450. I forget what they cost me but it seem

like on the

order of $5.00 of so, perhaps a bit more.

http://www.msdignition.com/

Look under "Fuel Management" and then under "Accessories"

Ed Anderson

Thanks, Ed. I ordered MSD part #2400 from Summitt racing.com When they
arrive, I will see if they fit.
Ken if you can bring a clip to Tracy's I can replace the baling
wire/duct tape holding it on :-) I hope to make it there if weather
looks OK. I fixed the front cover O-ring oil pressure problem and the
new engine is running well.

Chuck Dunlap

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.