Our man Richard Sohn came up with a big surprise
at this years Shady Bend Rotary Engine flyin.
I had the idea of using a steel plate and Royce (I think)
came up with the idea of just milling down the end housings
and using their wear surfaces.
There are a few details yet to be finalized but it
is 95% there. It uses a Subaru water pump so the
water pump location is flexible.
Richard did the entire thing on his CC (Cheap Chinese) mill :-)
Light weight aluminum end housing castings, detonation coated and ground
are too expensive and too problematic. This is a cost breakthrough and
a low technical risk, low tech solution.
As you may remember Richard successfully manufactures and sells adapters
that feed 2 cycle oil to the apex oil metering pump from a separate oil tank
instead of the engine having to burn that crud out of the oil pan.
Most of his customers are RX7 owners.
This will also work on a 13B and a 20b to further improve the already
excellent power to weight ratio.
Paul Lamar
Paul
In the drawing you show a "special seal", you never did say what it is for, and
what it is made from?
Royce
BTW, you left shady bend without giving me an opportunity to say good by. :-)
That was another idea. It was supposed to be a stainless heat shield
for the teflon O-ring in case the aluminum rotor housing shrank
as the result of an inadvertent overheat.
Sorry about that. I had to drive up to Richard's place a couple of hundred
miles away near Pensacola and then be back in Orlando in the opposite
direction to catch my flight out to LA this morning.
A few pictures I took at Richard's. Private runway and hangar
with Avid flyer. Presently powered by a Soob but will be converted
to the one rotor.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.