Subject: One rotor power to weight ratio breakthrough.
From: ACRE NL
Date: 10/29/2002, 4:49 PM

Our man Richard Sohn came up with a big surprise
at this years Shady Bend Rotary Engine flyin.
I had the idea of using a steel plate and Royce (I think)
came up with the idea of just milling down the end housings
and using their wear surfaces.

There are a few details yet to be finalized but it
is 95% there. It uses a Subaru water pump so the
water pump location is flexible.

Richard did the entire thing on his CC (Cheap Chinese) mill :-)

Light weight aluminum end housing castings, detonation coated and ground
are too expensive and too problematic. This is a cost breakthrough and 
a low technical risk, low tech solution.

As you may remember Richard successfully manufactures and sells adapters
that feed 2 cycle oil to the apex oil metering pump from a separate oil tank
instead of the engine having to burn that crud out of the oil pan.
Most of his customers are RX7 owners.

This will also work on a 13B and a 20b to further improve the already 
excellent power to weight ratio.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.