Our man Richard Sohn came up with a big surprise
at this years Shady Bend Rotary Engine flyin.
I had the idea of using a steel plate and Royce (I think)
came up with the idea of just milling down the end housings
and using their wear surfaces.
There are a few details yet to be finalized but it
is 95% there. It uses a Subaru water pump so the
water pump location is flexible.
Richard did the entire thing on his CC (Cheap Chinese) mill :-)
Light weight aluminum end housing castings, detonation coated and ground
are too expensive and too problematic. This is a cost breakthrough and
a low technical risk, low tech solution.
As you may remember Richard successfully manufactures and sells adapters
that feed 2 cycle oil to the apex oil metering pump from a separate oil tank
instead of the engine having to burn that crud out of the oil pan.
Most of his customers are RX7 owners.
This will also work on a 13B and a 20b to further improve the already
excellent power to weight ratio.
Paul Lamar
More pictures.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.