What your saying is that the aluminum will transfer sufficient heat from
the
> > oil to cause a meltdown of the Barry mounts? I didn't pay too much
> > attention to the Schertz beam motor mount emails since I was far
enough
down
> > the road with this design. Could you publish, on your web site or
resend
> > the notes on schertz design.
Don't the big Continental's have 4 mounting lugs on the lower case? Why do
they not melt their mount rubbers?
Lynn E. Hanover
They are three or more inches long and the 12 quarts of oil do not run 250 degrees
ever. They are also bolted to the case so the joint causes a reduction in
heat conduction. One third of the rotary cooling is done by the oil.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.