Perry Mick wrote:

I guess I was lucky on my return flight from Copperstate,
in that the fouling was just starting and the plugs quickly
recovered.  After I got back home it got much worse.
I still had about 20 gallons of evil gas in my tanks when
I got home.  The first couple short flights the fouling was
worse, it would not clear up.  So I took the plugs out and
cleaned them, added 10 gallons of mogas to the remaining
10 gallons of 100LL.  It was fine again until today.  Plugs
were once again fouled after operating a couple hours on
50% mogas/50% avgas. Would not clear.  Now I've
added more mogas, probably down to a 25% avgas mixture,
and I'm going to have to take the plugs out again and clean
them once more.

I'm using BUR9EQP trailing platinum plugs in all four
locations.  I think this makes the fouling worse since
the 9 is a colder plug.

--
Perry Mick
Duckt N7XR
http://www.ductedfan.com

Thanks for the report, Perry.

    You may correct about 4 BUR9EQP plugs contributing to your fouling
problem.  I use the BUR7 and BUR9 and get approx 20-30 hours of flying
before the plugs start to foul on the 100LL.  The old SAG (Sparkplug
Attention Getter) will put your heart to pumping faster.  I've never had the
engine indicate it was going to quit- but there is a power loss, the EGT
drops 200-300 DegF and the rpm drops approx 200-400 depending if one or both
chambers have fouled plugs.  At least that is my experience, but it can
certainly appear to be a fuel problem when you first encounter it.

Ed Anderson

Save some of those fouled spark plug guys and send them to me.
Aden is sending an MSD ignition system to me and I can experiment
a bit with the plugs on the dyno.

Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.