Richard is planning on using O-rings where ever possible.
So the sealing issues of the cobbled plates have not yet been dealt with? By
"O-rings" do you mean routing a channel for a face seal and using a
continuous length of Viton o-ring cord?
Yes but not Viton... TES :-) Forget Viton.
It is hard to mill O-ring slots that wander all over the place with a
regular mill.
It also appears the bearing surface was cut down by the same amount?
...Chrissi
I am not sure about that. Could be as this is only a one
rotor and the main bearing loads could be lower. Richard
did not want to separate the rear composite housing as it was too
much work putting it back together so I could not get a
picture of the inside.
Cozy Mk-IV 13B Turbo
www.CozyGirrrl.com
Chrissi@BlueMountainAvionics.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.