Stan from what I can gather(from the pictures) Richard has done the
opposite
to what Paul was considering ie. he has cut the rear housing and milled
the
rear-off (keeping the original wear plate) and replaced the rear /centre
with the plate and put on another cut down rear. Similar for the front.
I figure the rear might be longer and the front shorter therefore making
it
the same size. But I could be completely wrong - I don't know how he's
got
everthing working.
Might be a good argument to have a 2 piece new rear end incorporating a
new
water pump molded in - could this be done !?
I'm guessing, but from the look of it it must be a gasket seal for the
rear
section.
George (down under)
"Opposite"? It is exactly what I was considering. I only showed a drawing
of the front end housing. Do you mean opposite to the front housing?
Paul Lamar
By "Opposite" I'm referring to tha fact Richard is retaining the wear plate
section of the body of the end housings and replacing the other end with an
aluminium plate, whereas you'r proposal was replacing the wear plate (with
steel) and retaining the remainder.
I guess the jury is out on what is most suitable in either single rotor or
13b application.
George (down under)
You mis interpreted the drawing George.
It clearly states the water jacket is aluminum.
The whole purpose was to reduce the weight.
Royce came up with the idea of milling down the existing
end housing to retain the wear surface instead of using
the steel plate and going through the expense of hardening
and grinding.
What do you mean by this?
"I guess the jury is out on what is most suitable in either single rotor or
13b application."
The idea can be applied to all version. One rotor, two rotor, three rotor
or four rotor. A center housing for a 13B would be particularly easy
as there is no main bearing.
Mazda could of course obsolete all this by using the same steel/aluminum
technology on the end housings as they do on the rotor housings.
They are a bit behind the times as many automotive engines today
in high buck cars are all aluminum.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.