Subject: Schertz beam mount vs Oil Pan sandwich mount
From: ACRE NL
Date: 10/31/2002, 10:29 AM


Del, what is the weight of that aluminum sandwich plate?

A 4130 steel channel .050 thick 2.5 inches wide and one inch deep
and 18 inches long would weigh about 1.2 pounds. Plus of course
it would not conduct the heat to the rubber motor mounts.

Paul Lamar

Would you believe 9.5 lbs but that includes the bottom section of two Barry
mounts that are pressed in.  I had planned to mill out more of the aluminun
in the middle and back section.  Perhaps I will go with the Schertz beam!  I
couldn't find any 4130 steel channel or rectangular tubing on Aircraft
Spruce nor Wicks Aircraft sites.  Can you or others point me to a supplier
that will ship small quantities?  You also mentioned the use of Aluminum
channel for this application.  What thickness and width would you recommend?
What about putting a 1/8 inch shim under each of the attachment bolts to
separate the channel from the block oil pan/engine block otherwise your
still faced with heat conducting down the aluminum channel?

I can change to the Schertz beam without much of a problem at this stage in
the construction.

Yes I would belive it. Without holes a 5/8" thick  plate 14" by 18" is going
to weigh 15.75 pounds.

Obviously you have access to a mill. If you had to farm that out it
would be real real expensive. Another drawback to the sandwich
plate design is you have two joints to worry about oil leaking out
and not just one.

Just use 4130 steel sheet and bend it up. I recommend .050. You can get 
that from AC Spruce and any local sheet metal shop can bend it into
a channel section. Out where the rubber bushings go you can use
some of the aluminum plate or even phenolic blocks would work
to thicken it up and provide a surface for the rubber to bear 
against in shear.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.