Dan Ruggirello wrote:
I havn't yet purchased Paul's archive CD so maybe these issue have been
talked about....
1. Is the stock TurboII turbo the "twin scroll" design? For flight, is it
being used with the mechanisms to activate the high end inlet? I am
wondering if anyone has modified it to operate with upper end always on?
The complexity seems like a reason to go with a simpler aftermarket
turbo....
There are two exhaust gas runners on my stock 91 so I assume it it
twin scroll. Have not had it apart to be sure.
I am not clear on the terms "high end inlet" and "upper end".
Sounds like you are referring to the 93 and later dual sequential turbo
chargers. PL
2. Does tuning the intake work together with the turbocharger? I suspect
when the turbo is ramming air into the intake this changes the intake
dynamics and a tuned intake may not function well. Can a tuned intake work
well even when the turbo is off since there is ducting from the intake to
the compressor to cause turbulence? If I operate with intermittent turbo
(T/O and high altitude) just wondering if a tuned intake for low altitude
cruise is possible.
I assume it does as Mazda saw fit to incorporate tuning in all the
88 to 98 turbo engines. I am tuning mine so I will find out when
I get it on the dyno. PL
3. Is turbo life usually given for aftermarket turbos? If I operate a
turbo continuously, I would like to estimate a reasonable TBO. Has any
calculated a TBO for their turbo? Am just trying to balance the pros and
cons of continuous turbo operation.
You got me there. Nobody has enough hours on a turbo engine to know for
sure. PL
Continuous pros:
Increased fuel efficiency
No need for tuned intake (?)
No complex muffler
Continuous cons:
Rebuild turbo more frequently
Lower engine TBO (?)
Any thoughts?
Thanks,
Dan Ruggirello
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.