Subject: Rad inlet area requirements.
From: ACRE NL
Date: 11/6/2002, 5:38 AM


Paul - I printed out both of the recent posts on this, and am a bit
confused, but I think I am getting
the picture. When you say his answers are "about twice yours" I guess you
mean twice the
heat capacity - not twice the area required. I think the arithmetic is fine,
the apparent
significant difference is your "40 percent factor" with that out (set at
unity) your area
numbers would track his closely. 

That indeed was the root of the problem. I was using the average air velocity
out of the back side of the rad which is of course not the air velocity
in question. Brian fade on my part. 

Area in times Velocity in equals Area out times Velocity out plus what ever
expansion occurs due to added heat.

As you say the area numbers look larger
than working
practice on tractor air cooled airplanes (ie your neighbors RV 6). I think
that there are
at least a couple of significant other factors operating here. first - the
effectivee capture
erea is much larger than the opening area. Secondly, on a tractor
installation there is
a measurable increase in pressure behind the prop, especially at high power
settings
such as at climb. Also the thermal "inertia" of the system will often allow
you a full
power climb for sufficient time to achieve a reduced power operating point.

An interesting (but more complex) variation on your program could use
developed
horsepower - with a factor for cooling load, and altitude for density
variation.
An imperical factor relating speed and power could be added for the effect o
prop added pumping. If I get sufficiently bored, I might try to write
something
like that in my sanskrit QBAS with line numbers - Vance

Thanks for all your help on this Vance. Now we need some real
world numbers on the air temp coming out the back of the rad
and the air velocity going into the duct. I will resurrect the
the test box and put it back on the van for the air flow
numbers. I could of course rig up some remote temp gages for the
air temp coming out of the back side of the rad on the Dodge
Van and make some measurements while bombing up the Grapevine.
Not as good as a real world test on an airplane but
better than what we have now which is nothing.

This should solidify the theory to the point we can use it as 
tool to predict what will happen with specific rotary installations.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.