"Del Johnson, North Point Solutions, Inc" wrote:

Del Johnson wrote:

Does anyone have an accurate AutoCad or TurboCad drawing of the oil pan bolt
holes for the 13b turbo engine that they could send me?  I measured and
drafted one up but I'm not sure how accurate it is until I plot it out and
compare it to the hole spacing on the engine block.  If someone has already
done this and would share the cad drawing I would greatly appreciate it.

Thanks

Here is the trick I used Del. Buy some 1/8 inch thick transparent 
Lexan and lay it down on the flange of the old pan or on the bottom 
of the engine. Use a center punch to mark the holes. Then drill it
out and use it as a drill template there after. Plexi will also
work but it is not as tough as Lexan.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.