> > Jerry Hey wrote:

 > >
 > > Paul,   I made an adaptor to replace the top water pump neck with  a
 > > 1"  female pipe fitting.  The adaptor can either house the thermostat
 > > or be cut down even more if a thermostat is not being used. The short
 > > version is 1.375 inches high.  The thermostat version is 2 inches
 > > high.  I plan to use one inch AN fittings and hose through out.
 > > Jerry

 Hi, Jerry....Are you considering making these for resale?  Thanks in advance
 for your reply. Paul Conner

Well,  same old problem of pricing.  I can have ONE  at a time made
up for you or anyone else but it would cost $75.00.   If we could
make a pile of them, the price would be much lower.   If you are not
using a thermostat I think the price would be around $60.00 as one
set up is eliminated.  If you don't know whether or not you are going
to  use a thermostat, order the one with the housing.  It can be
machined  down  later  if you don't need it.    Jerry

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.