Al Gietzen wrote:
My engine has a coolant temp sender installed in the pump at the thermostat housing. I notice
that there is also a small threaded port just above the heater hose outlet on the rear end housing
(not far from the Tailing plug of #3 rotor). Is this for a temp sender; and is there any reason
to have one there (instead of, or in addition to) the one on the pump?
No real reason for both I guess but it would be nice to know what is going on.
If it was one or the other I would go with the pump as that would probably
be the hotter of the two as it is all of the water out of the block.
There is an allen head plug just below the oil filter on the rear housing; apparently for the oil
pressure sender, although it's curious that the plug is well painted in as though it has always
been there. Where else would there have been a pressure sender?
Thats it to my knowledge.
The hose barbs on the pump housing and the top of the rear housing originally for manifold cooling
Manifold cooling? You mean intake manifold heating. As I recall some engines have
a large hole in the intake side of the rear rotor housing that feeds water
to the intake manifold. Others use this for turbo cooling water
Hose barbs on the rear housing and the pump housing fed water to the
car heaters as I recall.
- is it best that these be
a) both plugged;
b) connected together; I would say connected together to make sure the
back of the engine is vented at all attitudes. If you are using a higher
pressure tank you can vent both of them to the top of the pressure tank.
c) plug the one at the pump and
connect the other as appropiate for bleeding air from top of engine; or,
d) none of the above.
I
raise this issue again since I had been told (Dave Atkins) to do option a), and then saw posted
here that it must be vented.
Thanks,
Al
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.