> What year water pump-please be specific. The FD (93+) pumps are made
 > differently, but still a 13B.
 > Would you like to do this test on a FD pump if I sent you one? How about
 > a 20B pump?
 > [Marc Wiese]

--------------------------
The test was done actually ON the engine, driving it with an electric motor
from the side. I cannot therefore do the test with any other pump.  The other
thing that should be noted is that my pump was modified in a manner similiar
to what Paul has shown before, to reduce the height so it would fit under the
cowl and to open up the inside.

As to model, I will read off the numbers on the pump tomorrow night, I think
the engine was about an 87-89. Bruce built it up with 4 port housings and
high compression (9.7) rotors.

Bill Schertz
KIS Cruiser #4045

So it must have been pumping the water through the block? 
Did you take some pictures?
Next step is pump it through the evap cores.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.