> > Jerry Hey wrote:

 > >
 > > Paul,   I made an adaptor to replace the top water pump neck with

a

 > > 1"  female pipe fitting.  The adaptor can either house the

thermostat

 > > or be cut down even more if a thermostat is not being used. The

short

 > > version is 1.375 inches high.  The thermostat version is 2 inches
 > > high.  I plan to use one inch AN fittings and hose through out.
 > > Jerry

 Hi, Jerry....Are you considering making these for resale?  Thanks in

advance

 for your reply. Paul Conner

Well,  same old problem of pricing.  I can have ONE  at a time made
up for you or anyone else but it would cost $75.00.   If we could
make a pile of them, the price would be much lower.   If you are not
using a thermostat I think the price would be around $60.00 as one
set up is eliminated.  If you don't know whether or not you are going
to  use a thermostat, order the one with the housing.  It can be
machined  down  later  if you don't need it.    Jerry

Jerry,  Put me on a long term purchace list.  No hurry, but if you get any
kind of group together I am in for the one built to accept the thermostat.

Dave Leonard

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.