Tom Webber wrote:
 >
 > Has anyone on this list Peripheral Ported there own housing?  If so was

it

difficult and how does
 > one start? Thanks for any advice.  Tom Webber

 Lynn Hanover did.

 Paul Lamar

Open the engine and transfer the intake port opening and closing events onto
the rotor housing at the apex seal. Extend the lines across the face of the
housing with a straight edge. Those two lines will be the top and bottom of a
very mild P port. Leave about 5/8" on the sides. Look at Paul Yaw's site at:
http://personal.riverusers.com/~yawpower/
He has a great series on This. His pieces are perfect. He may have prices for
doing the conversion.

Lynn E. Hanover

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.