> > Don Dunbar wrote:
> > >
> > > Hi Paul and group,
> > > I have just found the box that my PRSU planetary gear came in.
> > > Well the part number is YC3Z-7D006-CB planet. other numbers are
B969F
> and 061801 this on a Ford sticker with a bar code.
> > > On the other side of the box is 4R1 40BN Planet rear 845-F1
with more
> bar codes
> > > This is the six planetary gear.
> > > Hope this will help any one looking for gears.
> > > Regards Don
> This may also help
> George (down under)
Hi Paul,
The quote from Slausons seems to be the front gear set without the outer
holding teeth which could be better for a 2.85 ratio as the outer
rotates. Regards Don
Don,
Don't rightly know Mate! Luke from Slausons says the 6 pinion are all the
same (unlike the C6, 3 or 4 pinion).
You notice the blurb says that they (the gears) are interchangeable - I
don't believe that is the case.
I did quiz him on this, however Don I believe the 2.85 is a held Annular and
a driving
Planetary cage - someone tell me if I'm wrong ! I can still change the order
at this point in time if there's something else better, available.
BTW I'm planning on a 2.85 PSRU
George (down under)
The 2.85 holds the outer ring gear drive with the small sun gear and
power is output by the planet carrier to the prop.
Paul Lamar
Hi Paul,
I have the Slauson catalog and there is no way you could interchange the pinion carrier or the Annular.
You may be able to interchange the pinion gears themself to the forward or rear carrier.
Regards Don
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.