Subject: Periperal Port size and Timing (Leman engine)]
From: ACRE NL
Date: 11/22/2002, 8:29 AM


 > > Jerry Hey wrote:
 > >
 > > I think that my wife, Joy,  has determined the peripheral port size
 > > and timing  of the Leman Engine.  Here is what we did.   First I
 > > measured the inside vertical height of a l3B rotor housing.  This I
 > > determined to be 9.44 inches which we divided in two (4.72")since we
 > > were only interested in the top half where  the intake port is. Now I
 > > step out of the picture and Joy takes over.   The second step was to
 > > import the drawing of the Leman engine into PhotoShop where it was
 > > cropped to eliminate all but the top half of the rotor housing.  This
 > > was saved as an EPS and exported to PageMaker.  Then, in PageMaker
 > > she drew a line 4.72" long and scaled the eps image so that the
 > > inside top of the rotor housing and the horizontal center line
 > > matched up with the ends of the 4.72  line.   At this point the Leman
 > > drawing was at one to one.  Then, using Pagemaker  tools,  Joy
 > > measured  from the center line to the bottom and top of the P Port.
 > > It was 1.2" to the bottom and 3.188 inches to the top.  That is close
 > > enough to use a 2"i.d. x 2.25 o.d. aluminum tube for the insert.  The
 > > runners appear to be same diameter as the port.
 > >
 > > Don't know what I'd do without her.    Jerry
 >

          Jerry,

            Any chance of a drawing of the Lemans housing with these numbers
     shown for the artistic and math challenged among us?

 >          Kelly Troyer

I am working on it. Jerry

This might help Jerry.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.