Bulent Aliev wrote:

Hi Paul, here is my cut down intake manifold, which should be very similar
to the 20B one. This way I can use the original injector bosses and fuel
rails. The top fuel is a bit high for my liking and maybe I'll need small
blister on the cowling, unless someone has a suggestion for aftermarket one.
The fuel rails have built in fuel pressure sensor (the green plug) and fuel
pressure regulator on the end of the top one. Do you guys suggest of keeping
it or installing an external one?
On top of the cut tubes I will weld on the 3" x 3" plenum with the throttle
body.
Bulent

Cool! Looks like it will work great.  

I assume you had
a new input shaft made for Tracy's gear box. That stock 3rd
gen bell housing looks good too.
 
Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.