Jerry Hey wrote:

 > Paul, pass this along to Jerry and have him go to the site below.
Paul Yaw also has a clear article on using a dial wheel to time
with.  Jim Brewer

 Mazda Factory Peripheral Port

 IO 86° BTDC
 IC 75° ABDC
 EO 73° BBDC
 EC 65° ATDC

 Taken from Paul Yaw's excellent site--everyone should print the
technical articles and read over and over and .....
 http://personal.riverusers.com/~yawpower/dectech.html

Thanks Jim,   I was aware of those numbers from Paul Yaw's site.
What I am unable to do is compare those numbers with Leman engine
drawing.  The information is there.  If I keep begging and  hinting
long enough maybe one of the highly qualified participants of this
forum will do it just to shut me up.   Jerry

Hang in there Jerry I think Vance is working on it.
However you don't really need that information. It is just
academic. Copy the Lemans engine and run it.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.