Rolf Pfeiffer wrote:

Hallo Paul,

Allow me to contribute to the group. Since I worked at NSU in the late
60's in production development of the Wankel main parts, I am familiar
with it.

I made a dwg in ACAD LT, showing an intake and an exhaust port
arbitrarily positioned and lines indicating the timing in degrees per
eccentric shaft rotation.
For a true comparison with a Reciprocating engine the numbers should be
divided by 1.5 as the eccentric shaft rotates 270 degrees from TDC to
BDC.
The opening times can be interpolated and scaled between two points. The
circles at the end of the lines represent the radius of the Apex seal.

I trust this is helpful.

Regards
Rolf Pfeiffer

We are going to have to do something about dwg files.
Too much of my time is taken up converting them to something
everybody can read. Namely a gif. Not everyone has ACAD
and ACAD dwg files do not export or import from version to version.
Especially backwards. Same goes for DXF and to a lessor 
extent IGES.

In ACAD R12 you select configure and then select a plotter.
Most people don't own a real plotter so you can then select
a "Raster File Export" in ACAD speak. Then when it comes time
select "plot". This will generate a gif file of your drawing 
on your hard disk. So please.... send that instead of sending 
me a useless drawing file.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.