Subject: Thermostat housing
From: ACRE NL
Date: 11/27/2002, 7:14 AM


One inch Pipe or one inch AN hose? There is a large difference.
 One inch hose is one inch but one inch Pipe<[tube] is really about
 1 3/8 inch with close to twice the area and flow.

 IMHO one inch hose is a bit marginal. I am going to use Wiggins
 couplings like Bill Schertz  and Continental uses on their liquid
cooled
 engines with 1 3/8  OD tubing.

 Paul Lamar


By the way, 1-1/4" Aluminum Tubing just fits in the water pump inlet,
and can
then be welded to the casting. That is what makes the transition from
the ~25
degree angle to the vertical on my set up.  All the rest is 1-3/8" tube.

Bill Schertz
KIS Cruiser #4045

I was visiting friend of mine at the airport and he specializes only in P-51
Mustang repairs and maintanence. So I checked the cooling system. All
the coolant lines are aluminum tubing with beaded ends and short length
of hose, with triple hose clamps on each side.He told me that the radiator
cap is 18 psi.
Bulent


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.