George Lendich wrote:

Paul, Richard Sohn, others.

It would appear from past info that Richard Sohn is using PPort, for his Single rotor.
My question is that how will this run with a single at low RPM, considering the ongoing problems
with the 2 rotor PPort.

Is the problem with PPort, that it is getting too much fuel air mixture ? and could this be
adjusted further for idle i.e. finer adjustment at idle !!?

Richard how are you going with those siamesed end plates !?
George (down under)

Richard is using both. He can close off the p-port at low
HP levels. The main problem with p-ports at low power levels
is overlap. Exhaust products mixing with intake charge.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.