I checked the installation of the oil O-rings with the new sizes I got from Creavey. They worked perfectly and were very easy to install. You will need a little O-ring lube and a 2 by 8 to install them. They were also easy to remove with no signs of distortion. One of the secrets is if you reuse the old oil scraper rings they must be spotlessly clean inside and out. Soak them in carb cleaner for a few days. If you use new scraper rings this will not be a problem of course. The second thing to watch out for is don't nick the rotor wall between the two scraper rings when you remove them. Very very important!! Hopefully we can talk Dave Lemon into stocking these custom size teflon encap silicon oil O-rings. Everybody send a message to Dave at Mazdatrix :-) As I said these can be the same or just a little more than the stock oil O-rings from Mazda. The proper sizes are: 0.093" section 4.68 inch ID 0.118" section 4.33 inch ID I can vouch for the quality of the Creavey O-rings but some of those water TES o-rings from Mcmaster Carr I have seen are not as good. This is not to say they won't work. They just don't look as good around the joints as Creavey O-rings. Paul Lamar