> >>>>>> Jerry Hey wrote:

 >>>>>>>
 >>>>>>> Paul,  I have down sized the insert so that the outer housing
 >>>>>>> rim is
 >>>>>>> not milled.  Everything seems to be fitting nicely at this
 >>>>>>> point.  A
 >>>>>>> smaller hole for the pressure tap may be possible.  What do you
 >>>>>>> recommend Tracy?  I am going to put this away for awhile.  I am
 >>>>>>> sure
 >>>>>>> everybody is getting tired of it.    Jerry
 >>>>>>> --
 >>>>>>> Jerry Hey
 >>
 >>>>>  .25 is way overkill Jerry.  This is an application where smaller
 >>>>> is better.
 >>>>>  It helps smooth out the pulsations in MP.  1/16" would be plenty.
 >>>>>  There is
 >>>>>  no significant flow in this path.
 >>>>>
 >>>>>  Tracy Crook
 >
 >>> Thanks Tracy,  I suspected that but I did not know.  I will go with
 >>> .063 inch.   Jerry
 >> Jerry could you send me an ACAD file for your PPort?  I'd like to
 >> plot full scale and mess around
 >> with some machining.
 >
 >
 >> Tom Webber  my email is Twebber@cityofsacramento.org   thanks T.W.

 I would like one too please...

 conser@mcn.net

 Hans Conser

My drawings were done in Vector Works for Mac .  I can easily read a
DXF file but the ACAD guys have trouble with reading my DXF exports.
I have ordered an upgrade that may take care of this.  Jerry

Tailwind & Rotary Engine Support

http://www.j-winddesigns.com

mailto:j-winddesigns@thegrid.net

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.