Subject: New Layout for Tailwind (RV6A) rotary eng. mt.
From: ACRE NL
Date: 12/11/2002, 8:32 PM

Jerry Hey wrote:

Paul,  if one adds two tubes to the standard Tailwind/ RV6A  gear
mount to form an "X" between the gear sockets,  it is possible to
then run tubing braces from the "X" out to the  ends of the MMP.
These  replace the tube from the upper socket to the same place on
the MMP.  This will allow easy routing of just about any exhaust
design.  The "X" can be braced back to the  fuselage if necessary.
The tubes just clear the sides of  the wedge oil pan.  They do not
run below it, so no radiator space is lost. Triangulation looks like
the Kiss Cruiser if I remember it correctly.  Also, the rear MM can
tied to the "X"  Hope this makes sense.  No sleep last night.
Jerry
--
Jerry Hey

Tailwind & Rotary Engine Support

http://www.j-winddesigns.com

mailto:j-winddesigns@thegrid.net


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.