"Schertz, William W." wrote:

All,
I have added the point for actual flow through the two evaporator cores in
parallel to the previous curves that I published. Some points to note.

1. With the open loop system that I was using, the entire pumping capacity
(pressure capabilities) of the pump is not available for forcing fluid
through the radiators, therefore the point lies at a lower pressure and flow
than would be capable in a closed system

2. It falls very close to the curve-fit line shown before, therefore I am
happy with the result.

Bill Schertz

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.