Subject: New Layout for Tailwind (RV6A) rotary eng. mt.
From: ACRE NL
Date: 12/12/2002, 1:48 PM


 > > Jerry Hey wrote:
 > >
 > >Paul,  if one adds two tubes to the standard Tailwind/ RV6A  gear
 > >mount to form an "X" between the gear sockets,  it is possible to
 > >then run tubing braces from the "X" out to the  ends of the MMP.
 > >These  replace the tube from the upper socket to the same place on
 > >the MMP.  This will allow easy routing of just about any exhaust
 > >design.  The "X" can be braced back to the  fuselage if necessary.
 > >The tubes just clear the sides of  the wedge oil pan.  They do not
 > >run below it, so no radiator space is lost. Triangulation looks like
 > >the Kiss Cruiser if I remember it correctly.  Also, the rear MM can
 > >tied to the "X"  Hope this makes sense.  No sleep last night.
 > >Jerry
 >
 > >Tailwind &Rotary Engine Support
 > >
 > >http://www.j-winddesigns.com
 > >
 > >mailto:j-winddesigns@thegrid.net

 Jerry, I think the RV-6A is the designation for TRI gear.  I am a
ways off from worrying about
 engine mounts at this time, but I will need to fabricate one for
TRI gear as that is what my
 Tailwind will be.

 You guys are doing a marvelous job with innovations for using the
Mazda engine.  I am looking
 forward to seeing your Tailwind fly.

 > Steve -in Michigan

 Hi Steve,   Glad to see you are tuned in to this forum.  I guess
that RV6 indicates taildragger and 6A indicate nose dragger.   I
meant the taildragger, of course.   The tri-gear  TW or RV  is a
natural for the plan outlined above because  the structure
supporting the nose gear is already in place.    Makes for a very
clean, light weight engine mt with plenty of room for the exhaust.
Jerry

Tailwind & Rotary Engine Support

http://www.j-winddesigns.com

mailto:j-winddesigns@thegrid.net

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.