Subject: New Layout for Tailwind (RV6A) rotary eng. mt.
From: ACRE NL
Date: 12/12/2002, 12:45 PM


Jerry Hey wrote:

Paul,  if one adds two tubes to the standard Tailwind/ RV6A  gear
mount to form an "X" between the gear sockets,  it is possible to
then run tubing braces from the "X" out to the  ends of the MMP.
These  replace the tube from the upper socket to the same place on
the MMP.  This will allow easy routing of just about any exhaust
design.  The "X" can be braced back to the  fuselage if necessary.
The tubes just clear the sides of  the wedge oil pan.  They do not
run below it, so no radiator space is lost. Triangulation looks like
the Kiss Cruiser if I remember it correctly.  Also, the rear MM can
tied to the "X"  Hope this makes sense.  No sleep last night.
Jerry

Tailwind &Rotary Engine Support

http://www.j-winddesigns.com

mailto:j-winddesigns@thegrid.net

Jerry, I think the RV-6A is the designation for TRI gear.  I am a ways off from worrying about
engine mounts at this time, but I will need to fabricate one for TRI gear as that is what my
Tailwind will be.

You guys are doing a marvelous job with innovations for using the Mazda engine.  I am looking
forward to seeing your Tailwind fly.

Steve -in Michigan

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.