Marc Wiese wrote:

http://www.aerospacelogic.com/
Anybody using this stuff? Looks good for instrumentation.

Marc Wiese

Finn Lassen wrote:

Expensive! For a few of those instruments you could get the IK2000
http://www.i-ktechnologies.com/

Finn

Finn,
I have been looking at the IK2000 unit as well.  Looks like a lot of bang
for the buck.  However, I noticed the RPM readout only goes to 3000 rpm
which obviously won't do for a rotary installation.  Do you know if they
can/will rescale the rpms for rotary numbers and what type of signal is
required?
Mark

Don't know. You'll have to ask them. I'm not familiar with the  product.
Just came to mind when I looked at the instruments at
http://www.aerospacelogic.com/.

Finn

david mccandless wrote:

Mark, they make it work for Rotax and they rev over 6000, I think I read
that the tach goes to 9999. Dave McC

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.