Subject: Loud/ stock exhaust manifolds
From: ACRE NL
Date: 12/18/2002, 9:57 AM


I don't think those are tangential. Here is Dave Atkin's Inconel
tangential. Weighs less than four pounds as I recall and it
is indeed quieter than a 172 with a different sound of course.
The down pipe is a bit too restrictive IMHO.

Paul Lamar


Paul,

  Dave's muffler may well be Inconel and may be as light as 4 pounds. But
it appears from the photo that the exhaust flange is one of those 1/2"
thick mild steel pieces from Racing Beat. That flange alone probably weighs
8 pounds. Just dont want anyone to be disappointed if they spend huge $ for
Inconel expecting a 4 pound exhaust and wind up with one that weighs 12 pounds.

Mike Wills

You got a good point there Mike.
It is not as bad as you think. If it were 1/2 inch thick
it would be  about 4.7 pounds. 3/8 is more like it and that would
be about 3.5 pounds. The lightest thing to do is do what Everett did
and go to a four bolt exhaust flange.

Paul Lamar

Paul,
If separate exhaust flanges are used along with a muffler located adjacent to the exhaust ports the muffler must be built to allow for the expansion of the block or the welds for the stub pipes will surely fail.  This type of flange is good if used with pipes that allow for movement in all the components.

Ken Powell

Too things. You can drill the holes out in the flanges to allow
for slight movement or you can tie the two flanges together.
Just like the racing beat flange.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.