Subject: Ross drive cudos & cons
From: ACRE NL
Date: 1/8/2003, 7:24 AM


It always amazes that this handful of gears that I can hold
at arms length are strong enough to transmit 200 HP
continuously. They only weigh about six pounds.

Old Lou Ross was a genius for coming up
with this PSRU concept.

Thank you Ford and Lou Ross.  May Lou rest in peace.

Paul Lamar


-George Lendich wrote:

Paul,
You know their is some criticism of the Ross PSRU but when it all
boils
down
he did a marvelous job on getting it al together i.e. thinness of
housing
and shaft for weight savings and although the bearings are somewhat
minimalist in design, but they seem to work OK except for the rear
sun
gear
thrust bearing which was non existent - over all a bloody good job.
Interestingly I was speaking to a Diesel mechanic who has his own
large
business and he was telling me the M-Benz trucks have a similar
planetary in
the axels and guess what - they had serious thrust problems, it
would
seems
they omitted a thrust bearing.
Having very limited room guess what they used, flat brass
bearing -it
seems
it does the job !
George (down under)-

I agree George. Except for a few minor details like the missing sun
gear
thrust bearings the original Ross was brilliant. Too bad they are not
still
in business. It was a simple matter for Ross to add the trust bearings
on
the latter versions as in this picture. This consisted of several low
cost
needle bearings back to back reducing the RPM of each, greatly and
disproportionally increasing their life. This alone was a brilliant
idea.
A simple needle thrust bearing will take a tremendous amount of load
as long as the RPM is kept low.

Paul Lamar


-William Stevenson wrote:

Hi Paul   Do you know where I could get the thrust bearing installed for
a
Ross 2.17:1 redrive. Thanks Bill-

Anybody want to tackle this job for Bill? It will probably require some
grinding
on the stock Ford sun gear to gain clearance necessary for the
thrust bearing.

I am tempted do it but I am over committed right at the moment.

Paul Lamar

Not to disparage Ross's work, it was a nice piece, but I consider the
lubrication scheme to the weakest link in the design.  Fixing the missing
thrust bearing was easy by comparison.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

Well perhaps but there are plenty of them out there on 13B gyro
coptors running flat out at 7500 RPM with no mods to the lube system.

Ian, did you mod the lube system on your Ross 2.85?

BTW here is a sketch showing the space available on Finn's
2.17. Looks like you could get up to four needle bearings
in there.

Here too is a drawing of the Ross. The new sun gear thrust bearing
goes between parts 9 and 10.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.