Subject: 20B to divided turbo manifold
From: ACRE NL
Date: 1/10/2003, 7:02 PM

Chris Meadors wrote:

I'm planning on getting a Turbonetics T72 to go with my 20B to be
mounted in a 1991 RX-7 convertible.  The guy I talked to at Turbonetics
said that a 1.15 A/R would be recommended, but it only came in a divided
housing.

I was asking on an RX-7 mailing list about how a turbo manifold to go
between a 20B and a divided tangential turbine housing should be built.
  I had some concerns with the 3 rotors to 2 way divided turbo, how the
collator should look, and turbulence created by a single collated pipe
going to a flat divided flange.

Anyway, after asking on the list, BDC (Brian Cain) e-mailed me privately
and said I should talk to you.  So I'm guessing you can help me?  :)

Thanks.

--
Chris
1991 Convertible
(http://www.20bvert.com/)

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.