The stock Mazda injectors (normally aspirated) are around 50 lb/hr.  One
builder got away with using 36 lb/hr parts but I wouldn't recommend anything
less.  The EC2 can be used with either type (low or high impedance) but a 5
ohm resistor in series must be used with the low impedance type.  (This is
what Mazda does too)

I used the diffusers on the primary injectors but not on the secondaries.
Didn't seem to make any difference at high throttle where the secondaries
kick in.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

OK - 36 lb injectors are expensive - $370 for a set of 8 at Summit.  42lb are $459 and 50lb are $600 at Downs Ford.

Ken P.

The pressure for these ratings is 38 PSI.  The Mustang Mags carry several advertisers for these items.

Ken P.

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.